Home CISCO Switches How to set interface IP for switch? How can I route?
How to set interface IP for switch? How can I route? PDF Print E-mail
Written by Siva   
Tuesday, 02 November 2010 06:02

Use set interface commnad. Here I setup 10.10.1.1; so I can access my switch using this IP (telnet to this IP).

Here I am using set ip commnad to route all between 10.10.10.1. Use this IP as your "gateway" in your windows, linux, esx, sun solaris etc. So all boxes can be routed using this router,

 

#ip    

set interface sc0 10 10.10.1.1/255.255.0.0 10.10.255.255

       

set ip route 0.0.0.0/0.0.0.0         10.10.10.1  

 

Be remember if the line exist already with different IP; remove that line by typing same line with prefix "no" ; then use interface that you need.

 

WARNING: This will make lot of changes in your network; so dont play; do this during initial setup.

Last Updated on Tuesday, 02 November 2010 06:06
 
 

Advertisement

Featured Links:
HREmail.com
Looking for job? Try HREmail.com
Want to have CMS based Websites?
Try siliconwebcreators.com to CMS based websites.
VM Solutions Inc
For best VM solutions..
Digital Procedure Inc.
Looking for Oracle /SAP /Weblogic Consulting services? visit digitalprocedure.com